| Insert excerpt | ||||||
|---|---|---|---|---|---|---|
|
...
| Insert excerpt | ||||||
|---|---|---|---|---|---|---|
|
POS Tasks | |||||||||||||||||||
1. Ensure Access Locations exist and are active
|
| ||||||||||||||||||
Infrastructure Tasks | |||||||||||||||||||
1. Send request to Aspenware to enable or disable Pass Checker
|
| ||||||||||||||||||
Aspenware Arrival Tasks | |||||||||||||||||||
1. Create “AccessLocations” Collection
2. Create “Pass Checker - Hotlist Reason” Collection
|
| ||||||||||||||||||
1. Input Default Pass Checker POS Location ID
2. Create “AccessLocations” mapping(s)
|
|
3. Create Hotlist mappings
4. Update Pass Checker Languages Strings
|
|
Prerequisite Tasks
This section describes all requirements that must be completed before you can begin setting up this feature. Once these tasks are complete continue to the next section.
...
1. Create “AccessLocations” Collection
Go to the Collections tab.
Create a Collection by entering “AccessLocations” in the Name field, then clicking the ADD COLLECTION button.
...
2. (Optional) Create PassChecker Hotlist Reason” Collection
...
The Pass Checker POS Location ID is a setting from RTP|One, and can be sourced from your RTP|One administrator, (RTP|One/ Access Control Admin / Access Control Management / Access Location). This setting serves as a default lift or access point that passes will be validated against in the instance that additional “accesslocations” are not defined.
Go to the General tab and add and enter RTP|One’s Access Location Code (also referred to as the Location ID) in the Pass Checker POS Location ID field, then click the UPDATE GENERAL SETTINGS button.
...
2.
...
Create “AccessLocations” Mappings
If utilized, AccessLocation Mappings provides the ability to allow guests to check access to specific lifts. It also allows the resort to customize the Lift’s display name to the guest. If Mappings are not used, only the default Location ID setup in Step 1 will be used and no Lift Name or selection will be visible to the guestA minimum of one mapping must be entered or Pass Checker will not return results when a guest searches for their pass.
Go to Collections and select “AccessLocations”
...
In the Value field input the corresponding Lift’s Access Location Code (also referred to as Location ID) from RTP.
Then click the ADD COLLECTION ITEM button.
...
Repeat this process for additional Lifts if required. If necessary, you can edit your Collection Item by selecting it, then clicking the UPDATE COLLECTION ITEM button. You can also delete using these same steps by clicking the DELETE COLLECTION ITEM button.
3. (Optional) Create Pass Checker HotList Reason display mappings
...
Value: Input the hotlist code from RTP|One.
Click the ADD COLLECTION ITEM button.
...
Repeat this process for additional hotlist codes if required. If necessary, you can edit your Collection Item by selecting it, then clicking the UPDATE COLLECTION ITEM button. You can also delete using these same steps by clicking the DELETE COLLECTION ITEM button.
4. (Optional) Update Pass Checker Language Strings
Languages have default values but can be updated to match your display needs. Update the desired field then click the UPDATE LANGUAGE button to save the changes.
...